2 West Street Hambledon Hampshire PO7 4RW

Proposal

It is proposed to install the Ohme Pod EV Charging Unit as follows: By splitting the meter tails cables with henley blocks inside the electric meter cupboard, from here we will fit a distribution board to contain an MCB or RCBO 40A switch and if required, a type A RCD switch. This distribution board is dedicated for the charging unit and its size is around 26cm high and 16cm wide. From the distribution board, we will run a 6mm2 EV Ultra cable with a cat5e to the charging unit. This involves running the cable internally from the hallway, into the living room which in turn allows us to reach the outside wall at the rear of our property. The cable will be secured using P clips and will be boxed in using slimline wooden edge trim. The charging unit will be installed at the rear of property by fixing a mounting plate using drills and screws, from there the charging unit can be slotted on with ease and locked into place. When it comes to drilling into the wall we can look to mainly utilise the mortar, however, if the property is listed then there is a higher chance the mortar uses lime mortar which is corrosive and likely to be less secure when drilling in and will likely be avoided by our engineers. The dimensions of the Ohme Pod EV Charging Unit is 230mm x 140mm x 100mm. This particular unit has been chosen due to its small size and discreet nature, in keeping with the Grade II Listed status 2 West Street. It is also an untethered charging unit which is aesthetically pleasing when not in use as nothing will be visible from the road (West Street). It is also the official unit supplied by Audi which is another reason the charging unit was chosen. All works to be carried out an official Ohme EV Charging Unit installer.