Planning applications in CV37

Remove T1 pine, T2 cypress, T3 fir. Undertake tree works as detailed on application form and in accompanying information.

Discharge of condition 3 (floor slab level), condition 4 (scheme of remediation), condition 5 (cycle parking), condition 7 (foul & surface water details), condition 8 (boundary treatment), condition 10 (external lighting), condition 11 (scheme of landscaping), condition 12 (renewable or low carbon energy generating facilities), condition 13 (water management statement) and condition 14 (broadband facilities) of planning permission reference W/24/02366/FUL

Non-Material Amendments to ref W/24/02366/FUL for minor alterations to plan

Re-thatching of roof (part retrospective)

Discharge of Conditions 12 (Drainage) & 15 (Super Fast Broadband) of planning permission W/26/00391/FUL

Proposed single storey side extension.

Standard steel portal frame building. Open sided with no proposed cladding. Fibre cement sheet roofing.

T1 - ash - Reduce approximately 30%, 4-5 metres as pictured, to reduce sail and branch failure risk.

T1 - lawson - Labelled T2 on sketch plan. Fell to ground, outgrowing area and subsidence concerns, to replant with Holly. T2 - ash - Labelled T4 on sketch plan. Selective end weight thinning 25% to reduce branch failure risk.

T1 - pear - Crown reduction and lifting of canopy, decrease the overall height and spread to 4.5metres T2 - Silver birch - Fell T3 - European spruce - Fell

Discharge of condition 3 Biodiversity Net Gain Plan of planning permission 25/02208/VARY

T1 - Cherry tree - crown reduction by 1.5-2.5 on top and 1-2m on sides to reduce the windail effect of the canopy and shape. Remove deadwood. Clear around phone line to give a minimum of 1m clearance around the line and prune back from power line to give a minimum 2m clearance. T2 - Dawn redwood - Remove Deadwood, reduce lower canopy overlong branches by roughly 1-2m to bring in line with the rest of the canopy to reduce the windsail effect of the overlong branches to prevent snapping.

T1 - Oak - Remove dead wood for health and safety reasons. T2 - Lime - Re pollard back to old growth points as part of 4 year management cycle.

Single storey rear extension.

Rebuilding of dismantled section of external wall of Barn B.

T1 - Black pine - Remove 2no. branches overhanging road, as per annotated photograph

T1 Robinia - Re-pollard to the previous pruning points, removing approximately 3-4m of regrowth throughout the crown. Remove basal epicormic growth. The proposed work will maintain appropriate clearance from the building, reduce loading on -the retained framework and continue the established management cycle T2 Prunus- Fell

The solar PV system will be installed on the rooftops at the above mentioned site. The installation will be installed via a flat roof mounting kit on the rooftops. Please refer to the attached rooftop designs.

- A1 ash - Reduce height by 11 metres - A2 ash - Reduce height by 17.5 metres - A3 ash - Reduce height by 17.5 metres - H hawthorn - Reduce height by 1.5 metres - DP pine - Reduce height by 16 metres (tree is dead) - DSB1 silver birch - Reduce height by 13 metres (tree is dead) - DSB2 silver birch - Reduce height by 13 metres (tree is dead) - DSB3 silver birch - Reduce height by 13 metres (tree is dead) - DSB4 silver birch - Reduce height by 13 metres (tree is dead)

- T1 yew - Reduce height of tree by approximately 1.37 metres (4.5 foot)

- T1 ash - Fell to ground level (to allow refurbishment and building works, tree is encroaching on building and boundary lines)

Notification for Prior Approval for the proposed change of use of an agricultural building (Barn 4) to 2 no. dwellinghouses and associated operational development.

Notification for Prior Approval for the proposed change of use of an Agricultural Building to 6 Dwellinghouses (Class C3), and for building operations necessary for the conversion.

Notification for Prior Approval for the proposed change of use of an Agricultural Building to 2 Dwellinghouses (Class C3), and for building operations necessary for the conversion.

T1 and T2 - lawson cypress - Poorly, 60% dead, request to remove.

T1 - silver birch - Out growing area, fell to ground.

Single storey rear extension to form a new family space and wetroom

T1-Prunus - Reduce canopy from 8m to 4m

To reduce 2 Willow tree's after one recently failed, Both trees are mature Weeping willow trees, approx. 40ft, a crown reduction by 6ft all round, on both trees maintaining foliage to keep a screen on the property. Tree's marked T2 and T18 on sketch plan. Tree T2 has recently snapped a limb in the wind. Undertake tree works, as detailed on application form and in any accompanying information.

Erection of a garden kitchen

- G1 Leylandii hedge - Reduce height to approximately 1.82 metres (6 foot) from approximately 2.43 metres (8 foot)

- T1 Norway maple - Reduce crown by approximately 1 metre both in height and laterally. Crown lift by approximately 2 metres - T2 hawthorn - Remove deadwood - T3 yew - Remove small, detached branch within crown - T4 lime - Remove significant deadwood throughout crown - T6 holly - Crown lift to approximately 2.5 metres above pathway only - T8 yew - Crown lift to approximately 2.5 metres above pathway only - T9 lime - Reduce height by approximately 6-7 metres. Reduce lateral spread by approximately 1-2 metres. Remove epicormic growth around stem base - T10 yew - Remove moderate deadwood throughout crown - T11 yew - Fell and grind stump to below ground level - T12 variegated maple - Prune out reverted rootstock growth - T13 purple plum - Reduce crown by approximately 2 metres both in height and laterally. Remove deadwood - T16 serviceberry - Trim into tight topiary-style ball - T17 serviceberry - Trim into tight topiary-style ball - G1 hornbeam - Remove all support systems. Lightly trim the sides and upper surface to maintain a formal square profile - G2 birch - Prune to provide approximately 0.3 metres clearance from the adjacent hedge, avoiding the removal of primary branches - G3 hornbeam - Lightly trim the sides and upper surface to maintain a formal square profile - G4 hornbeam - Remove all support systems. Lightly trim the sides and upper surface to maintain a formal square profile

- T1 ash - Crown reduction of up to 3 metres in both height and laterally, back to previous pruning points (signs of ash die back). Crown thin 5%. Remove dead overhanging branches out of utility cables - T2 red plum - Crown reduction of up to 3 metres in both height and laterally, back to previous pruning points (growing over public footpath and entrance to car park)

- T1 lime - Fell (dead)

- T1 sycamore - Create a pollard at approximately 5-6 metres (see photograph P1)

- T2 sycamore - Remove limb back to trunk (hanging directly over greenhouse of 6A Avenue Road, as per annotated photograph) - T3 sycamore - Remove hanging limb back to upright limb (as per annotated photograph)

- T1 Leylandii - Crown reduction radially by 0.5 metres at the lowest and widest points, graduating up to re-shape (as per annotated photograph)

Amendment to planning permission 25/00744/FUL (date of decision 15/05/2025). Wall between existing kitchen and utility room to be retained. Wall to continue to first floor level to form wall for bedroom 2. Reduction of width to window in kitchen and French doors to bedroom 2 as above. Replace drawing nos 2025/008 and 2025/007 with 2025/008a.

- T1 willow - Crown lift the canopy to approximately 3 metres from the surface of the river, to remove lower secondary growth

Single storey rear extension

Felling of one large spruce tree. It provides no amenity value to us or our nearest neighbour. It competes for space and light with a much larger mature hornbeam. It does lean towards our neighbours garden but not dramatically but if it was to fall would likely damage the neighbour?s workshop. We will replant a replacement tree (Katsura) elsewhere in our garden.

Proposed single storey rear extension to form enlarged lounge and kitchen facility with internal space planning alterations

- T1 purple leaf plum - Reduce height from 5.5 metres to approximately 4.5 metres. Prune off split branch - T2 Leylandii - Reduce height by 1 metre to retain at approximately 4.5 metres. Reduce overhang to footpath by up to 1 metre, to retain spread of approximately 2.5 metres - T3 Portuguese laurel - Prune back from lawn edge by approximately 2 metres to retain 4 metre spread. Reduce height by up to 1 metre to retain at approximately 5 metres - T4 cypress - Cut off at approximately 50mm above ground level (dead stump) - G1 Leylandii 2x - Grub out (both dead) - G2 ash 2x - Reduce height by approximately 2.5 metres to retain at 5 metres and 6 metres respectively - G3 Leylandii 6x - Reduce height by up to 2.5 metres to retain at approximately 10-11 metres. Prune protruding spreading branches by up to 1 metre

- T1 willow - Repollard back to previous pollarded points, removing approximately 4 metre sections to prevent failure

- T1 Prunus - Cut back overhanging branches off fence (as per annotated photograph) - T2 Prunus - Reduce canopy by 2-3 metres (as per annotated photograph)

- T1 Laburnum - Fell

- T1 unknown species (flowering ornamental) - Reduce both in height and laterally, back to previous pollarding points from 2024 (reduced by 1 metre then), to stop trees obstructing road and pedestrian pavement - T2 unknown species (flowering ornamental) - Reduce both in height and laterally, back to previous pollarding points from 2024 (reduced by 1 metre then), to stop trees obstructing road and pedestrian pavement - T3 unknown species (flowering ornamental) - Reduce both in height and laterally, back to previous pollarding points from 2024 (reduced by 1 metre then), to stop trees obstructing road and pedestrian pavement - T4 unknown species (flowering ornamental) - Reduce both in height and laterally, back to previous pollarding points from 2024 (reduced by 1 metre then), to stop trees obstructing road and pedestrian pavement

Installation of a garden office

Installation of a garden office

- T1 Quercus robar - Lateral extent reduction 2-3 metres to appropriate natural target pruning attachment points. To include crown clean of minor fragile deadwood - T2 Quercus robar - Lateral extent reduction 2-3 metres to appropriate natural target pruning attachment points. To include crown clean of minor fragile deadwood and ivy sever