6 Belmont Crescent Abergavenny Monmouthshire NP7 5LF

Proposal

The proposed development comprises the removal of the existing rear conservatory and the construction of a single-storey rear extension together with a rear infill section to the existing detached dwellinghouse. Following the removal of the conservatory, a rear infill section will be constructed to align with the original rear wall of the dwellinghouse (the utility room projection). This infill does not project beyond the original rear wall and serves to square off the rear elevation of the original building. The infill element has an overall width of 4.5 metres, which is less than half the width of the original dwellinghouse, and is clearly identified on the proposed plans. A single-storey rear extension will then be constructed, projecting a maximum of 4.0 metres from the original rear wall of the dwellinghouse, measured perpendicular to that wall. The extension spans approximately 9.0 metres wide by 4.0 metres deep, as shown on the proposed floor plan. The extension will have a flat roof construction with a maximum overall height of approximately 2.5 metres, measured from existing finished ground level, and will remain below 3.0 metres in height. The roof form, height, and relationship to the existing dwelling are shown on the proposed rear and side elevations. The development does not involve any alteration to the principal (front) elevation of the dwellinghouse and does not extend forward of it. No new or altered vehicular or pedestrian access is proposed. There will be no changes to the existing access arrangements, driveway, or parking provision. Surface water from the proposed extension roof will be drained via new rainwater goods and connected to the existing drainage system, replicating the existing method of drainage serving the dwellinghouse. Foul drainage arrangements will remain unchanged. All works are confined within the existing residential curtilage of the dwellinghouse. The precise siting, footprint, and dimensions of the proposed infill an